If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Snowboard gouge repair
Hi,
I have an older K2 Snowboard with a few gouges on the bottom, nothing too deep. Would it be possible to wet sand the entire base, fill the gouges with 2-ton epoxy and resand. I would then respray with some automotive paints and clear coats then hot wax. The only reason I would use automotive paints and epoxy is cause thats what I have on hand. I really don't care about the design on the bottom, so I thought this would be a good solution and would be free. Thanks, Alex |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ski repair | [email protected] | Nordic Skiing | 5 | March 28th 07 08:18 PM |
Snowboard repair expert question. | Bob | Snowboarding | 4 | June 28th 05 12:18 PM |
Ski Repair | [email protected] | Nordic Skiing | 0 | March 1st 05 10:36 AM |
fix gouge or ignore? | David | Snowboarding | 3 | October 28th 04 05:55 PM |
how to repair snowboard trousers become waterproof again | Martin | Snowboarding | 2 | February 11th 04 11:24 PM |