A Snow and ski forum. SkiBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » SkiBanter forum » Skiing Newsgroups » Snowboarding
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Industry standard hole pattern EXACT dimensions



 
 
Thread Tools Display Modes
  #1  
Old April 13th 05, 08:18 PM
Aegis
external usenet poster
 
Posts: n/a
Default Industry standard hole pattern EXACT dimensions

I have looked for a week RE this info, but the great google does not
reveal its secrets to me. Does anyone know what the exact dimensions
are for an "Industry Standard" bolt pattern and the burton 3-hole
patterns?

Ads
  #2  
Old April 13th 05, 08:31 PM
Neil Gendzwill
external usenet poster
 
Posts: n/a
Default

Aegis wrote:

I have looked for a week RE this info, but the great google does not
reveal its secrets to me. Does anyone know what the exact dimensions
are for an "Industry Standard" bolt pattern and the burton 3-hole
patterns?

Industry standard is 4 cm X 4 cm, M6 threads. I presume that's measured
on centre. I believe Burton is a 4.2 cm equilateral triangle.

Neil

  #3  
Old April 13th 05, 08:34 PM
lonerider
external usenet poster
 
Posts: n/a
Default

The omniscient Mike T posted this a few days ago on BOL about the
industry standard 4x4 bolt pattern and the Burton 3D pattern.

====
4x4 is a 40 mm square. 3D is a 42 mm equilateral triangle. So a
strictly 4x4 disk is not compatible with a 3d pattern. Some bidning
manufactuers - Catek, Salomon, K2, and Burton themselves come to mind -
have designed disk that are "universal". This usually involves half of
the 4x4 holes being wider to accomodate both a 42 mm and a 40 mm
disntance between screws.
===

Aegis wrote:
I have looked for a week RE this info, but the great google does not
reveal its secrets to me. Does anyone know what the exact dimensions
are for an "Industry Standard" bolt pattern and the burton 3-hole
patterns?


  #4  
Old April 22nd 05, 11:05 PM
Aegis
external usenet poster
 
Posts: n/a
Default

Thanks so much!!!!!!

 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 05:49 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 SkiBanter.
The comments are property of their posters.