|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
How to remove Salomon SNS Profil binding?
On Feb 9, 4:07*pm, jeff potter wrote:
I have a set of skis with the Salomon SNS Profil manual bindings
What's a good way to remove them?
You've gotten a lot of good advice already. We have a more direct
approach for the plastic cap at the tail end of the binding baseplate
- take a very small straight-blade screwdriver and stand it straight
up in the molded slot, rap sharply and drive the blade straight thru,
then pry it up. You can reuse it, we throw it out and replace w/ a
new one when the binding is remounted.
The screws are # 3 Pozi-Drive, many shops sell the screwdrivers, many
hardware stores also sell Vermont American bits for 1/4" magnetic bit
holders which we chuck into battery operated drills and yes, we always
adjust the clutch settings on them.
One thing not mentioned is what happens to the holes left over in the
ski. We always plug them w/ the proper sized plastic plug from an
assortment we have. The hole is glued, plug tapped into the ski and
lightly sanded flush w/ the topsheet. Of course, if the holes are re-
used they are glued again before sending the screws home.
|Thread||Thread Starter||Forum||Replies||Last Post|
|replacing rubber plug for Solomon Profil binding||mike||Nordic Skiing||6||December 25th 07 01:29 PM|
|Using Salomon Pilot 2 Classic Boots With Older Profil Classic Binding.||ADK Skier||Nordic Skiing||7||November 8th 06 09:45 PM|
|HELP: Profil binding dias-assembly||Tony Curran||Nordic Skiing||5||November 29th 05 01:39 AM|
|a profil binding question pls.||[email protected]||Nordic Skiing||0||November 14th 05 07:55 PM|
|removing rear fastener on sns profil binding||Chris Crawford||Nordic Skiing||3||February 26th 05 01:29 AM|