|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 4th 03, 06:50 PM
|
|||
|
|||
Marker 9.2 installation
Hi guys,
does anybody know how to install/adjust Marker 9.2 bindindgs. I bought used volkl and i can fit my boots in, but since my boots are smaller, the center of the boots about 1/3 inch (~1 cm) higher (closer to the top) relatively to the ski center. Is it too bad? Any suggestions? Should i redrill the ski - if i do, does somebody have an instractions? Thanks in advance, Shtutchka 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Marker Binding Problems | Andrew | Alpine Skiing | 16 | September 2nd 03 01:26 AM |
Linear Mode
