If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Newbie Binding Setup Question
Just got my Lamar board and a set of Flow Pro 19 bindings, and my
question is: Am I supposed to set up the bindings slightly rear or forward of center? And is the standard 20" - 21" stance width measured from center to center of bindings or from inside to inside of bindings? Thanks, Joe |
Ads |
#2
|
|||
|
|||
Newbie Binding Setup Question
|
#3
|
|||
|
|||
Newbie Binding Setup Question
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Binding Question | Wes Gardner | General | 0 | February 22nd 04 01:45 PM |
flow binding warning | [email protected] | Snowboarding | 8 | February 18th 04 03:04 PM |
Newbie Bindings Question | Joe Blanchard | Snowboarding | 5 | February 16th 04 12:42 AM |
can only ride with my back binding loose - why? | Dmitry | Snowboarding | 8 | December 12th 03 01:25 AM |
Newbie Question | Will | Snowboarding | 3 | December 11th 03 10:58 PM |