If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Burton Board and Ride Bindings
Hello I recently bought a Burton board and a set of ride bindings but when
mounting I noticed I can only get 3 screws through the center piece into the deck where on my other board I could get all four, is this normal as Burton hole positions are a little bit different, and 3 screws per binding is that OK ? Or does one use Burton bindings with Burton boards which sounds kind of strange ?? Thank you ! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Forward Lean Question - w/ new Ride bindings | toddjb | Snowboarding | 5 | December 9th 03 03:36 PM |
Should I wax BRAND New board before first ride?? | Kempi | Snowboarding | 1 | December 7th 03 11:19 PM |
Burton Dominant Sizing------Please help | Lee | Snowboarding | 5 | November 21st 03 05:22 PM |
BINDINGS: Salomon SPX carbon, Drake Podium, Burton C-16 | dhl28 | Snowboarding | 24 | November 21st 03 04:44 PM |
Board sizing... | Brett | Snowboarding | 1 | October 19th 03 11:07 PM |