|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 7th 04, 04:11 AM
|
|||
|
|||
zardoz notwax on extruded bases
I've been reading a lot about zardoz notwax, and how great it works,
but I've got an extruded base on my board, and the only thing I've read is these bases will not absorb the notwax. I wouldn't mind re-applying sometime during the day, but not after every run. Does anyone have any experience with this product on extruded bases? thanks, bruce 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
