|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 15th 03, 01:07 AM
|
|||
|
|||
Changing bindings
I'm thinking of changing bindings on a Pair of Fischer SCS Skatecut from NNN R3
to Pilot. Anything I should be concerned about in making this switch? 
|
| Ads |
|
#2
November 15th 03, 01:39 PM
|
|||
|
|||
|
Changing bindings
(Baronner) wrote in message ...
I'm thinking of changing bindings on a Pair of Fischer SCS Skatecut from NNN R3 to Pilot. Anything I should be concerned about in making this switch? Check out http://www.sierranordic.com/tech_tip_seven.html Also, if you do not want to pay $17 for special screwdriver, make your own out of standard "Phillips".
|
|
#3
November 15th 03, 09:03 PM
|
|||
|
|||
|
Changing bindings
Thanks, that's exactly the information I needed.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Good Indo on Decks, Boots, and Bindings?? | Barry Dinglehopper | Snowboarding | 4 | January 2nd 04 03:25 PM |
| salomon bindings / burton boards | Joe | Snowboarding | 6 | December 18th 03 09:48 PM |
| Flow Bindings | mr E | Snowboarding | 1 | November 15th 03 06:32 AM |
| Installing 75 mm, 3-pin, NN bindings ? | Sven | Nordic Skiing | 1 | October 31st 03 01:10 PM |
| Changing bindings? | martin | European Ski Resorts | 1 | August 25th 03 04:07 PM |
Linear Mode
