If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Cut down swix team pole
Did you heat the basket neck in hot water for awhile? If it's close,
the neck's expansion is sometimes enough. wrote: Yes, the taper is not that visible to the eye, but I finally got around to checking, and the old tip will not fit. I will measure it sometime, to see if I can get a tip to fit. Not a huge priority, as it is a backup, and I do not break poles very often. Thanks, -- Andrew Hall (Now reading Usenet in rec.skiing.nordic...) |
Ads |
#12
|
|||
|
|||
Cut down swix team pole
romat writes:
romat Did you heat the basket neck in hot water for awhile? If it's close, romat the neck's expansion is sometimes enough. It is not close enough for that, the outer dimensions are about the same on the basket and broken tip. wrote: Yes, the taper is not that visible to the eye, but I finally got around to checking, and the old tip will not fit. I will measure it sometime, to see if I can get a tip to fit. Not a huge priority, as it is a backup, and I do not break poles very often. Thanks, -- Andrew Hall (Now reading Usenet in rec.skiing.nordic...) -- Andrew Hall (Now reading Usenet in rec.skiing.nordic...) |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Replace single, old, Swix Team CT2 Pole shaft | Nordic Skiing | 10 | February 13th 07 11:26 AM | |
Swix Pro-Fit suits and Elite Jacket | NordicSkiRacer | Nordic Skiing | 0 | December 2nd 05 04:25 PM |
New Zealand with the USST/Subaru Factory Team | Nathan Schultz | Nordic Skiing | 4 | July 16th 04 01:46 AM |
Vordenberg & US Ski Team Clinic @ Gear West | p.bowen | Nordic Skiing | 1 | July 5th 04 07:41 PM |
Pole revolution? | Anders Lustig | Nordic Skiing | 4 | February 7th 04 01:44 AM |