If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cinch / Flow users: Stepping in on hills???
I'm a brand new user to the K2 Cinch binding. I'm also a relatively new boarder.
The Cinch has just been an awsome, fast binding to get in an out of without the requirement of sitting down and strapping in. However... I'm still having fits strapping in on less-than-flat terrain. This is only a problem for me at the top of a limited number of lifts. I've begun working on a technique. Instead of fighting to keep the board motionless, I'm trying to slide sideways while working the highback. I'm getting better, but having a ton of trouble controlling the board while positioning my foot, reaching down and securing the highback. How do you regular Flow and Cinch riders do it? Any advice would be greatly appreciated. |
Ads |
#2
|
|||
|
|||
speede541 ) writes:
How do you regular Flow and Cinch riders do it? Any advice would be greatly appreciated. WIth either my freeride/flows or carving board/plates I line up the board perpendicular to the hill toeside pointing downhill, dig the downhill edge in to keep it still, step in/on and close it up and go. Steve. |
#3
|
|||
|
|||
Hmm, interesting....
I use regular strap bindings, and never sit down to strap in. If the hill is really steep, like something I hiked to get up, with super soft snow, I'll sit. Face downhill, dig heels of board into hill, now board is flat, step in front first, then rear. What's the big deal? |
#4
|
|||
|
|||
I usually face up the mountain and dig the frontside into the snow while
keeping the balance by holding to the ground with the opposite side hand (left binding open - right hand). Then you step into the binding from the top and close it down. Voila! That way you don't have to sit down and it works on pretty much any steepness. Or put the foot into the binding before the end of the lift. That way you only have to close the highback instead of fiddeling the boot into the binding, too. Another advantage of this "technique" is, that you have more control exiting the lift. Greets, Saim "speede541" schrieb im Newsbeitrag ... I'm a brand new user to the K2 Cinch binding. I'm also a relatively new boarder. The Cinch has just been an awsome, fast binding to get in an out of without the requirement of sitting down and strapping in. However... I'm still having fits strapping in on less-than-flat terrain. This is only a problem for me at the top of a limited number of lifts. I've begun working on a technique. Instead of fighting to keep the board motionless, I'm trying to slide sideways while working the highback. I'm getting better, but having a ton of trouble controlling the board while positioning my foot, reaching down and securing the highback. How do you regular Flow and Cinch riders do it? Any advice would be greatly appreciated. -- speede541 |
#5
|
|||
|
|||
Now it gets interesting!
3 replies, 3 different techniques for NOT sitting down and strapping in. I wonder if different stances influence our strapping in styles. I mostly run 27/7. |
#6
|
|||
|
|||
LeeD wrote:
Now it gets interesting! 3 replies, 3 different techniques for NOT sitting down and strapping in. I wonder if different stances influence our strapping in styles. I mostly run 27/7. In my old Burton SI's I mostly used to stand facing uphill and dig my heel egde in. On very steep slopes, I faced uphill with my hands on the floor and my toe edge dug in. Anything is easier than sitting down with these bindings because you have to put some weight behind your foot when clipping in. The other method I used was to just clip in while moving. I used this quite a lot to get off chairlifts without stopping at all. As for stance. I change between around 15/9 and 6/-3 depending on what I'm doing. Octes |
#7
|
|||
|
|||
"LeeD" ) writes:
Hmm, interesting.... I use regular strap bindings, and never sit down to strap in. If the hill is really steep, like something I hiked to get up, with super soft snow, I'll sit. Face downhill, dig heels of board into hill, now board is flat, step in front first, then rear. What's the big deal? Unlike strap bindings it helps to have your weight forward instead of back against the highback to close up the binding. I don't think angles would have much of an impact (15, -5 on FR and 55/50 on carving) compared to binding style. They all work but for me the advantage for toeside downhill is that it keeps the weight off the highback while you are pushing it up. With heelside down there is the potential for your weight to shift onto your toes while pushing the highback foreward which may release your edge prematurely and away you go! And if you are on firm snow base (aka ice), its harder to dig in the toeside uphill enough to keep the board still. Try both standup methods and choose which one works for you. Steve. |
#8
|
|||
|
|||
Quote:
I did try digging the heel-side edge into the snow. I have a little trouble maintaining balance, but as soon as I begin sliding my foot into the binding, the motion and the pressure I place on that side of the board usually breaks me free and gets me sliding fakie down the hill. But reading all of your replies, I'm convinced I just need some time and practice. I'll be sure to give the toe-side edge a whirl, as well. I do have an easier time holding still in that orientation. |
#9
|
|||
|
|||
speede541 wrote: LeeD Wrote: Now it gets interesting! 3 replies, 3 different techniques for NOT sitting down and strapping in. Yes, quite interesting. I did try digging the heel-side edge into the snow. I have a little trouble maintaining balance, but as soon as I begin sliding my foot into the binding, the motion and the pressure I place on that side of the board usually breaks me free and gets me sliding fakie down the hill. But reading all of your replies, I'm convinced I just need some time and practice. I'll be sure to give the toe-side edge a whirl, as well. I do have an easier time holding still in that orientation. -- speede541 |
#10
|
|||
|
|||
When riding Flow, I always got on my knees w/ board perpendicular to
the hill below me. On knees it's easy to push feet into foot strap. Pulling hi-back up while sitting is tough. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Salmon Hills update | Bingham | Nordic Skiing | 4 | July 20th 04 01:54 AM |