Need help with K2 clicker & Burton board

I was wondering if anyone could send me a diagram or give me instructions on how to mount K2 clicker bindings on a burton board. I bought the bindings a couple years ago, and since have lost the instructions. Just got a new board and I'm heading out to Vail tomorrow morning. Extremely quick help would be appreciated. Thanks y'all.

SnoDude28

Nothing magical here, just mount as you would to a regular 4x4 pattern
board. You may have less options to choose from, but you can usually
spin the Clicker disc around until it lines up with 3 holes. So,
that's it, make sure you have 3 screws going through each binding. Put
them about shoulder width apart. Go ride.

If the discs don't work, you may be able to go into a shop that sells
K2 bindings and have them give you a newer disc that better fits the 3
hole patterns. Shops usually have extra discs floating around and will
help you out.

You also might need to turn the discs so the screw slots are
perpendicular to the board for a more customized width.