If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
broken snowboard
I going to buy a Nidecker Snowboard, but there is a problem that snowboard
is broken (delamination after one season in mountain) and fixed by authorised serwis of nidecker. Please tell me that snowboard will be good for beginer in snowboard and that defect of snowboard won't be dangereus for snowboarder. All pleasure is my Wojmag |
Ads |
#2
|
|||
|
|||
broken snowboard
If you get a really good deal on it go for it. If not do not get
ripped off. The delam is hard to fix. I did not see the board so I do not know how bad it is. But I had a board from K2 which delaminated and I got it fixed but it just kept delaminating by the end of the season. Most of the time it is cosmetic. The problem is that the snow gets between the sheets and freezes and melts. Make sure they give you a huge discount on it, what do they say if it delaminates again? Will they replace it, repair it or is it a second and you get the shaft? The problem is that it is caused by a defect in the manufacturing process. The question is what was the defect and how serious is it? |
#3
|
|||
|
|||
broken snowboard
"sporty.zimowe" wrote in message ...
I going to buy a Nidecker Snowboard, but there is a problem that snowboard is broken (delamination after one season in mountain) and fixed by authorised serwis of nidecker. Please tell me that snowboard will be good for beginer in snowboard and that defect of snowboard won't be dangereus for snowboarder. All pleasure is my Wojmag Usually delams are caused by bad manufacturing (incorrect layup, not enough glue etc). Unless you are getting it for next to nothing, or it still carries a good warrenty, I'd stay away from it. I did have one board that delamed and the manufacturer fixed and I didn't have any problems after that. Turned out that they put a layer of fiberglass on backwards. snoig |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Snowboard Forums ? | Rob | Snowboarding | 2 | December 31st 03 03:58 PM |
Snowboard Manufacturers and Retail Outlets | BarB | Snowboarding | 2 | November 25th 03 02:07 AM |
FS: Oxbow snowboard Jacket brand new | Craig Corbett | Snowboarding | 1 | October 6th 03 04:08 PM |
Is this snowboard too long for me? | Gary H | Snowboarding | 5 | September 25th 03 02:44 PM |
Snowboard FAQ - URL only | Switters | Snowboarding | 0 | August 6th 03 07:54 AM |