If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
NIS Plates and Rossi Rottefella Xcelerator Skate Binding
The screws have stripped out on my favorite pair of skis. I had the
thought to screw down a Rottefella NIS plate to the ski and use the clip on Rottefella NIS Bindings. This is a long shot but does anyone know of a source for NIS plates which aren't already bonded to a ski. Secondly Rossi just released info on a new Rottefella Xcelerator which has new flex bit system. Anyone know of the improvement this has over the current Rottefella Skate Binding. I know on my Rottefella skate bindings the smaller return flex bit becomes dislodged. The pin securing it is very small and moves out of the slot holding it. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rottefella Tele Release Plates Question (TRP100) | Pete Chrisbacher | Backcountry Skiing | 2 | March 14th 05 06:45 PM |
Brand New Rossi F3 X-ium Skate Skis 194cm. | [email protected] | Nordic Skiing | 0 | January 31st 05 09:07 PM |
New NIS Boot/Binding System From Rossi, Madshus, Rottefella and Alpina | [email protected] | Nordic Skiing | 0 | January 26th 05 11:30 PM |
binding choice: salomon 912 vs. look p12 (or rossi axial 120) ? | [email protected] | Alpine Skiing | 1 | January 7th 05 10:05 PM |
Ski binding lift plates | og | Alpine Skiing | 10 | September 29th 04 01:34 PM |