If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
sharping edges
Hi !
When I do a 1 degree sharpening of the bottom edge of the snowboard - do I do it only around the nose and the tail of the board or on the complete edge ? thanks Friedemann |
Ads |
#2
|
|||
|
|||
sharping edges
the edges to worry about are between the board's contact points - the tip
and tail should be detuned with a gummy stone so they don't catch "Friedemann Wolpert" wrote in message ... Hi ! When I do a 1 degree sharpening of the bottom edge of the snowboard - do I do it only around the nose and the tail of the board or on the complete edge ? thanks Friedemann |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Edges not holding sharpness? | Jon Bond | General | 2 | January 17th 04 07:20 AM |
rusting edges = big problem?? | Sapphiro15 | Snowboarding | 3 | August 18th 03 02:23 PM |