Burton custom bindings

Anyone knwo of a link online to burton custom bindings manual. Just
bought some online and they're way more adjustable than my old bindings,
but didn't come with any instructions for set-up.

They were allegedly set for size 9 boots, (custom mediums) but the back
support is WAY forward, which seems wrong!

Any help greatly appreciated

Cheers

mark&vikki

I am unsure if Burton posts a manual on their site.
For stance positions go to
http://www.cs.uu.nl/~daan/snow/stance.html.
It covers pretty much everything to do with stance.
The degrees for the stance u can figure out using the mounting disk.
Just have the disk pointing foreword, and you can read the measurement
on the notches on the outside of it.

They were allegedly set for size 9 boots, (custom mediums) but the back
support is WAY forward, which seems wrong!

If you are talking about the forward lean adjustment, ie. how far back
or foreword the back of you bindings are, you simply snap the switch on
the back of the high-back up and slide it up or down.
Moving it up makes your bindings go back farther.

Rotating the backs of your bindings is not nessesary, but you can
rotate them so they are parallel to the board instead of the bindings
to get better control. You just have to loosen the screws on either
side at the back of the baseplate.

Good luck! :P