If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
NNN R3 binding
Is there any structural difference between the R3 skate and the R3
classic bindings (manual) or is the only difference in the flexors? It looks like there are slots on my classic bindings that would take a rear flexor. Visually the two binding look the same from photographs on both in online catalogues other than the rear flexor. So, could a classic binding be turned to skate mode by adding a rear flexor and possibly changing to a stiffer front flexor? Colin |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
AT binding help | ShredTheGnar | Backcountry Skiing | 42 | September 9th 04 09:56 PM |
WTB: XC Binding | jim | Marketplace | 0 | January 24th 04 09:11 PM |
binding screws | Al | Alpine Skiing | 3 | January 12th 04 06:40 PM |
75 m.m. Three pin Binding | Joseph S.Gollinger | Nordic Skiing | 2 | December 22nd 03 12:49 AM |
Binding DIN Settings | Clint Marshall | Alpine Skiing | 8 | December 17th 03 09:06 AM |