If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need help with K2 clicker & Burton board
I was wondering if anyone could send me a diagram or give me instructions on how to mount K2 clicker bindings on a burton board. I bought the bindings a couple years ago, and since have lost the instructions. Just got a new board and I'm heading out to Vail tomorrow morning. Extremely quick help would be appreciated. Thanks y'all.
SnoDude28 |
Ads |
#2
|
|||
|
|||
Nothing magical here, just mount as you would to a regular 4x4 pattern
board. You may have less options to choose from, but you can usually spin the Clicker disc around until it lines up with 3 holes. So, that's it, make sure you have 3 screws going through each binding. Put them about shoulder width apart. Go ride. If the discs don't work, you may be able to go into a shop that sells K2 bindings and have them give you a newer disc that better fits the 3 hole patterns. Shops usually have extra discs floating around and will help you out. |
#3
|
|||
|
|||
You also might need to turn the discs so the screw slots are
perpendicular to the board for a more customized width. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need a new wide board - Burton Bullet? | Matt | Snowboarding | 4 | May 13th 04 08:29 PM |
Burton board identification | Rob | Snowboarding | 1 | February 17th 04 05:38 PM |
Burton Cascade board length | T. Hariharan | Snowboarding | 7 | December 24th 03 09:30 AM |
Burton Board and Ride Bindings | The Kid | Snowboarding | 1 | December 12th 03 06:24 AM |
FS: burton board bundle | Sean | Snowboarding | 1 | December 1st 03 07:50 PM |