A Snow and ski forum. SkiBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » SkiBanter forum » Skiing Newsgroups » Snowboarding
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Snowboard binding setup



 
 
Thread Tools Display Modes
  #1  
Old November 20th 04, 06:07 PM
Tony
external usenet poster
 
Posts: n/a
Default Snowboard binding setup

Hey,

I've just bought my first snowboard and a pair of bindings, I need to
obviously attach these to each other. Any one point me to a website or
offer advice to the various ways of doing this. i.e. how far from the
tip should the front boot be etc etc.

Cheers

Tony
Ads
  #2  
Old November 21st 04, 10:49 PM
Riding Wolf
external usenet poster
 
Posts: n/a
Default



You could try this:

http://www.cs.uu.nl/~daan/snow/stance.html

oooh looks handy. Gonna use that for my stance on my new board. The stance
on my current board is still about what they set it in the shop (only
changed the angle of my back-foot)


  #3  
Old November 21st 04, 11:15 PM
Tom
external usenet poster
 
Posts: n/a
Default

http://www.cs.uu.nl/~daan/snow/stance.html

oooh looks handy. Gonna use that for my stance on my new board. The stance
on my current board is still about what they set it in the shop (only
changed the angle of my back-foot)


In my second season I started to sort of "listen" to symptoms on the slopes and
I managed to work out a good set-up just by feel. Some things were more
obvious; pain in calf muscle solved by allowing back of bindings to go back
more. Weight distribution is a key one. My board's a bit long so I simply moved
my stance forward and it felt fine. You gradually get a feel for the physics of
a board almost by instinct. Enjoy!
  #5  
Old November 22nd 04, 05:40 PM
bri719
external usenet poster
 
Posts: n/a
Default

og wrote:

All boards have a centered stance that is usually marked o the board.
Start with that and go from there.



yeah, there's also a 4x2 bolt pattern (one for each binding) on most
every board. if you start by placing the binding in the middle four
holes on each, you will be centered over the board. eventually he may
want to move his feet slightly back or farther apart, depending on the
type of riding.

also I tend to let beginners know, if you set the front foot to about 15
degrees and rear foot to 5-10 degrees (whatever is comfortable), then
that's a good starting point.

good luck to OP

bri

--

* enjoying the karma *
remove LKJSDFJSD from address to email


  #6  
Old November 22nd 04, 08:04 PM
Tony
external usenet poster
 
Posts: n/a
Default

EMOVE (Tom) wrote in message ...
I've just bought my first snowboard and a pair of bindings, I need to
obviously attach these to each other. Any one point me to a website or
offer advice to the various ways of doing this. i.e. how far from the
tip should the front boot be etc etc.

Tone-boy,

You could try this:

http://www.cs.uu.nl/~daan/snow/stance.html

And also just put "snowboard stance" into Google and see what's there (the
first hit is the above one).

Bear in mind everyone's different though. I ride a board technicallya bit too
long for me, and with very slightly ducked stance, but it suits me fine and I
ride it with ease. So you might find a few tweaks either side of the
theoretical norm works for you.

Tom



Nice one Tom, Just the thing I was looking for.

Cheers

Tony
  #7  
Old November 29th 04, 07:33 PM
Jay
external usenet poster
 
Posts: n/a
Default


"Tony" wrote in message
m...
EMOVE (Tom) wrote in message
...
I've just bought my first snowboard and a pair of bindings, I need to
obviously attach these to each other. Any one point me to a website or
offer advice to the various ways of doing this. i.e. how far from the
tip should the front boot be etc etc.

Tone-boy,

You could try this:

http://www.cs.uu.nl/~daan/snow/stance.html

And also just put "snowboard stance" into Google and see what's there
(the
first hit is the above one).

Bear in mind everyone's different though. I ride a board technicallya bit
too
long for me, and with very slightly ducked stance, but it suits me fine
and I
ride it with ease. So you might find a few tweaks either side of the
theoretical norm works for you.

Tom


I'd say that's the no. 1 thing to remember. In fact I'd go further than a
few tweaks. In the group I go boarding with we all have completely different
setups. One of my mates rides a symmetric duck stance, another almost
alpine. We all do pretty much the same things but it's just what is most
comfortable and gives you most control. I hate it when kids tell me they
have this or that angle because that's how their particular snowboarding
idol does it.

Jay.





 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Newbie Binding Setup Question Joe Blanchard Snowboarding 2 February 26th 04 07:57 PM
flow binding warning [email protected] Snowboarding 8 February 18th 04 03:04 PM
can only ride with my back binding loose - why? Dmitry Snowboarding 8 December 12th 03 01:25 AM
broken snowboard sporty.zimowe Snowboarding 2 December 3rd 03 03:43 PM
Pilot binding system -- what's the point? Ken Roberts Nordic Skiing 1 August 14th 03 03:28 PM


All times are GMT. The time now is 08:15 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 SkiBanter.
The comments are property of their posters.