If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sharpened edges problem?
Hi!
A friend of mine phoned from a peak in Austria earler, bemused to find that after getting her edges sharpened, the board was 'catching' and 'throwing her off'. This sounded really bemusing but she assures me nothing else has changed in her set-up. Any ideas? Tom |
Ads |
#2
|
|||
|
|||
A friend of mine phoned from a peak in Austria earler, bemused to find
that after getting her edges sharpened, the board was 'catching' and 'throwing her off'. This sounded really bemusing but she assures me nothing else has changed in her set-up. Sounds like they didn't bevel the base edge when they sharpened. |
#3
|
|||
|
|||
mindpowerz wrote:
Hi! A friend of mine phoned from a peak in Austria earler, bemused to find that after getting her edges sharpened, the board was 'catching' and 'throwing her off'. This sounded really bemusing but she assures me nothing else has changed in her set-up. Any ideas? She's probably a skidder. She should take it back to the shop and get them to detune the tip and tail a bit. Neil |
#4
|
|||
|
|||
Thank you both for the replies; I spoke with Kate today and she went
back to the shop with these two suggestions. Nice one! Tom |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Protecting Edges from Rust | Clint Marshall | Alpine Skiing | 2 | March 23rd 04 01:05 PM |
New board comes with dull edges?! | Yemi | Snowboarding | 0 | February 12th 04 06:46 PM |
Soft edges? | Jon Bond | Alpine Skiing (moderated) | 3 | January 7th 04 10:54 PM |
Google Usenet Group Problem | Tim Dudley | Nordic Skiing | 0 | October 1st 03 01:52 PM |
rusting edges = big problem?? | Sapphiro15 | Snowboarding | 3 | August 18th 03 02:23 PM |