|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 9th 05, 11:44 PM
|
|||
|
|||
I need BOOTS for my Ride-DEVICE / CP3 bindings....
I have the Oxygen CP3 bindings which are the same as the Ride-Device
bindings....I love these bindings, but since they no longer make them I have trouble finding new boots. I'm looking for a source for a boot, new or used that will fit my big foot (size 12, but boot size 13 cuz they run small usually). If someone has a boot laying around they no longer use, or know of where I can find some old stock please let me know. Thanks!! Jack 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| trying to determine a good board for my needs | [email protected] | Snowboarding | 30 | May 19th 05 02:44 PM |
| old burton boots don't fit new burton bindings. | fotoobscura | Snowboarding | 0 | February 13th 05 10:53 PM |
| Boots for Flow bindings? | corbeau | Snowboarding | 0 | February 4th 04 01:41 AM |
| Good Indo on Decks, Boots, and Bindings?? | Barry Dinglehopper | Snowboarding | 4 | January 2nd 04 03:25 PM |
| Forward Lean Question - w/ new Ride bindings | toddjb | Snowboarding | 5 | December 9th 03 03:36 PM |
Linear Mode
