If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Zirconium sanding belts
Are these less prone to loading than Aluminum Oxide belts - or are
they just longer lasting in the event that I don't irreparably gunk them up like I usually do? Care to share any tips on a) avoiding loading in the first place and 2) salvaging those for which I've ignored (a)? JP ***************** Not happy with the tracking adjustment on the PC352VS..... |
Ads |
#2
|
|||
|
|||
Zirconium sanding belts
On Fri, 14 Nov 2003 16:17:36 -0500, Jay Pique
wrote: Ack! Ignore the previous post. JP ******************* Use a 10grit belt for proper base prep. |
Thread Tools | |
Display Modes | |
|
|