If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Changing bindings
I'm thinking of changing bindings on a Pair of Fischer SCS Skatecut from NNN R3
to Pilot. Anything I should be concerned about in making this switch? |
Ads |
#2
|
|||
|
|||
Changing bindings
(Baronner) wrote in message ...
I'm thinking of changing bindings on a Pair of Fischer SCS Skatecut from NNN R3 to Pilot. Anything I should be concerned about in making this switch? Check out http://www.sierranordic.com/tech_tip_seven.html Also, if you do not want to pay $17 for special screwdriver, make your own out of standard "Phillips". |
#3
|
|||
|
|||
Changing bindings
Thanks, that's exactly the information I needed.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Good Indo on Decks, Boots, and Bindings?? | Barry Dinglehopper | Snowboarding | 4 | January 2nd 04 03:25 PM |
salomon bindings / burton boards | Joe | Snowboarding | 6 | December 18th 03 09:48 PM |
Flow Bindings | mr E | Snowboarding | 1 | November 15th 03 06:32 AM |
Installing 75 mm, 3-pin, NN bindings ? | Sven | Nordic Skiing | 1 | October 31st 03 01:10 PM |
Changing bindings? | martin | European Ski Resorts | 1 | August 25th 03 04:07 PM |