If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
rusting edges = big problem??
how do i get around this :S
|
Ads |
#2
|
|||
|
|||
rusting edges = big problem??
"Sapphiro15" sapphiro15 at hotmail wrote in message
... how do i get around this :S Wipe the edges of your board dry after you get home from boarding.. If you want to get rid of the unsightly rust, you can polish them off with a gummy stone. It's a piece of rubber with sand impregnated in it. Should take it off without de-tuning your edge. -Bruce |
#3
|
|||
|
|||
rusting edges = big problem??
how much detuning can u do on your edges before your cant do it anymore?
"Bruce Chang" wrote in message y.com... "Sapphiro15" sapphiro15 at hotmail wrote in message ... how do i get around this :S Wipe the edges of your board dry after you get home from boarding.. If you want to get rid of the unsightly rust, you can polish them off with a gummy stone. It's a piece of rubber with sand impregnated in it. Should take it off without de-tuning your edge. -Bruce |
#4
|
|||
|
|||
rusting edges = big problem??
"Sapphiro15" sapphiro15 at hotmail wrote in message ... how much detuning can u do on your edges before your cant do it anymore? As much as you want. You can just keep filing the edge until all the metal is gone. Heck you can keep filing into the deck if you want, it's all the same to me.. "Bruce Chang" wrote in message y.com... "Sapphiro15" sapphiro15 at hotmail wrote in message ... how do i get around this :S Wipe the edges of your board dry after you get home from boarding.. If you want to get rid of the unsightly rust, you can polish them off with a gummy stone. It's a piece of rubber with sand impregnated in it. Should take it off without de-tuning your edge. -Bruce |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Edges not holding sharpness? | Jon Bond | General | 2 | January 17th 04 07:20 AM |