If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
mounting new bindings
Arrgh. I am mounting a new set of 4X4 bindings. I've never mounted
bindings before. Do any of you have a good refrence on this? I don't want to fark it up. |
Ads |
#2
|
|||
|
|||
mounting new bindings
Center them on the hole pattern and go from there. Measure the stance width
and make adjustments accordingly. "phil cerne" wrote in message m... Arrgh. I am mounting a new set of 4X4 bindings. I've never mounted bindings before. Do any of you have a good refrence on this? I don't want to fark it up. |
#3
|
|||
|
|||
mounting new bindings
|
#4
|
|||
|
|||
mounting new bindings
Make sure your heels or toes don't overhang the edge of the board too
much. If you can, get them so they are even on both side regarding overhang. You may have to adjust the heelcup forward or back once you get the bindings mounted. Whatever you do, DON'T overtighten the bolts/screw holding the binding center plates. On 10 Dec 2003 18:29:59 -0800, (phil cerne) wrote: Arrgh. I am mounting a new set of 4X4 bindings. I've never mounted bindings before. Do any of you have a good refrence on this? I don't want to fark it up. |
#5
|
|||
|
|||
mounting new bindings
Mount me
|
#6
|
|||
|
|||
mounting new bindings
Thanks for the advice. I have a more specific question. I'm
installing a generic set of 4X4 bindings onto a K2 deck. All that came with the bindings was the bindings themselves, the center disk, rubber gaskets for the bottoms of the bindings so as to not fubar up the deck, and two sets of screws [2 lengths]. I guess the big question is that once I have the gasket on the bottom of the bindings, I just put 'em where I want 'em stancewise, and cinch down the center plate with the screws. Do I need any other hardware? Is there any good way for me to eff this up? (phil cerne) wrote in message om... Arrgh. I am mounting a new set of 4X4 bindings. I've never mounted bindings before. Do any of you have a good refrence on this? I don't want to fark it up. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Forward Lean Question - w/ new Ride bindings | toddjb | Snowboarding | 5 | December 9th 03 03:36 PM |
FA:Snowboard Bindings | David Beamish | Snowboarding | 0 | November 24th 03 06:04 PM |
Flow Bindings - Mounting discs | mr E | Snowboarding | 0 | November 23rd 03 04:08 AM |
Flow Bindings | mr E | Snowboarding | 1 | November 15th 03 06:32 AM |
Bindings: Logic vs Reality | Skitzo | Snowboarding | 12 | November 12th 03 03:58 PM |