|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 6th 07, 06:04 AM
posted to rec.skiing.snowboard
|
|||
|
|||
Problem mounting Ride bindings on Burton board
I just got a used Burton Canyon. Trying to mount my Ride SPi bindings on it, I
discovered that the hole spacing is not compatable with the holes on the Ride bindings. The Ride board has two rows of 4 holes, the Burton has two rows of 2 holes, and 4 center holes. Unfortunately, the spacing between the holes are slightly more than on the Burton board than the Holes on the bindings. Is it possible to get a plate for the ride bindings to fit the Burton board, or is there some other solution, other than new bindings? Bob F 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Burton UnInc..........Big problem, please help !!!!! | [email protected] | Snowboarding | 3 | November 30th 06 08:29 PM |
| I need suggestion with a new board - maybe the gnu carbon high bean? ride decade? burton twin? Please help | [email protected] | Snowboarding | 1 | April 14th 06 11:53 PM |
| Opinions on Ride Fuse boots and Ride EX bindings | slartibartfast | Snowboarding | 1 | November 24th 04 03:28 AM |
| Burton Board and Ride Bindings | The Kid | Snowboarding | 1 | December 12th 03 06:24 AM |
| Un-mounting and re-mounting bindings | John Skewes | Nordic Skiing | 3 | November 10th 03 09:09 PM |
Threaded Mode