NO NO NO NO DO NOT PUNCH OUT THE PIN. DOING SO COMPROMISES THE BINDING
AND COULD CAUSE UNEXPECTED FAILURE.

The push button piece pops off. Its been a while since I used these
bindings so I am a little vague on how to pop the button off. I think
you slide itforward using a screw driver as a wedge. I do remember that
getting it bacl on was a lot easier than taking it off.

Jeff

wrote:
Look at the binding from the side, find the pin holging the rubber
stopper and push the pin out with somthing sharp. Like, a fine flat
screwdriver will do it. Then pull the stopper out and you will get
access to that screw. I hope you are using a heavy-duty phillips: those
srews ruin cheap screwdrivers.