Beginners Board
OK - I'm the first to admit. I'm a big, fat *******.
185CM/100KG or 6'1"/220LB depending on your accent.
Skill level is beginner-low intermediate.
Intended use is freeride, the half pipe just isn't my scene.
The board I'm looking at with interest is a Supermodel 168 (second
hand) with the appropriate bindings. Probably a few years old but
seems in good condition (no gouges, scrapes, bloodstains).
From my research (ya gotta love the internet!) it seems as though the
supermodel can be a bit 'floppy' - I guess my concern is that I may
outgrow this board a bit quick.
Also, I've seen a few comments about how Burton boards in general tend
to lose what little stiffness they start out with.
Other comments are that with the Super, you should select a board
~10CMs longer than you usually use.
Questions:
1. Is this likely to be a board I can use for a while without
outgrowing it?
2. Is the 'over-flexibility' and degradation of these boards an
issue?
3. Would I be better off with some other design in a ~160ish length?
4. How would I tell the manufacture year of this board? Did the
graphics change much?
Thx,
Mick.
|