Thanks for the advice. I have a more specific question. I'm
installing a generic set of 4X4 bindings onto a K2 deck. All that
came with the bindings was the bindings themselves, the center disk,
rubber gaskets for the bottoms of the bindings so as to not fubar up
the deck, and two sets of screws [2 lengths].

I guess the big question is that once I have the gasket on the bottom
of the bindings, I just put 'em where I want 'em stancewise, and cinch
down the center plate with the screws. Do I need any other hardware?
Is there any good way for me to eff this up?

(phil cerne) wrote in message om...
Arrgh. I am mounting a new set of 4X4 bindings. I've never mounted
bindings before. Do any of you have a good refrence on this? I don't
want to fark it up.