DIN Chart - Atomic - Where can I find one?
lal_truckee wrote:
Here's the process; Set the DIN; select from your calibrated cadaver set
a properly sized cadaver; insert cadaver's foot in your boot; insert
boot in binding; wrap strap wrench around cadaver's calve; attach torque
wrench to strap wrench; torque until release, or cadaver's tibia
spirals; if tibia spiraled, lower DIN setting one notch, get fresh
cadaver, repeat process.
Re-stock cadaver collection from Igor's Calibrated Cadaver Bargain
Basement - known as ICCBB to the initiate.
You got shares in them or something ?
Any fule kno that the obvious way to do it is start at DIN 1 and work up
until the cadaver's tibia spirals. THEN back off 1 setting. HTH HAND
|