Edgar wrote:
If the handle can be unbonded by heat (i.e. hot water), it is probably
glued using ferrule cement or glue. Pole ferrule glue is applied by
heating the glue and applying to the stick. Replace the grip, properly
positioned, before it hardens as it cools. Same process for replacing
backet/ferrules. A full service ski shop should have furrule glue.

To remove, heat as you have been instructed, You do not need to add
new glue except where you cut the glued section of the stick off.

Edgar

Why not hot melt glue used for crafts and various fixits?
gr