Burton Board and Ride Bindings
Hello I recently bought a Burton board and a set of ride bindings but when
mounting I noticed I can only get 3 screws through the center piece into the deck where on my other board I could get all four, is this normal as Burton hole positions are a little bit different, and 3 screws per binding is that OK ? Or does one use Burton bindings with Burton boards which sounds kind of strange ?? Thank you ! |
Burton Board and Ride Bindings
Yep mate,
Burton uses the 3D system (3 screws) while the others uses the 4x4 system (4 screws). I switch my (Burton 3D) binding regular between my Burton board and my Duotone Board (4x4) no problem at all.... Note that some disk are compatible with one or the other than you need other disks. AFAIK it is even patented by uncle Burton..... They thought (probably) to sell more boards and bindings together when deviate from the 4x4 principle. Please correct me when wrong, the 4x4 idea came from F2. Keep on riding, André "The Kid" wrote in message .cable.rogers.com... Hello I recently bought a Burton board and a set of ride bindings but when mounting I noticed I can only get 3 screws through the center piece into the deck where on my other board I could get all four, is this normal as Burton hole positions are a little bit different, and 3 screws per binding is that OK ? Or does one use Burton bindings with Burton boards which sounds kind of strange ?? Thank you ! |
All times are GMT. The time now is 09:56 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
SkiBanter.com